キーワード：未分類

Unless the elongated "daddies" pleasantly surprised, and now you can take them straight without breaking off. for 4.8mm 4.8mV (0.96mΩ)
I shopped in several places.
The terminals are not magnetic. However, all "dads" have noticeably thicker metal than the corresponding "mothers" S – thickness, where through a slash – this is when in dads the actual part that is inserted into the mother is two-layer. drop on male-female connection at 5A current: I started to run out of terminals, I decided to buy some. Well, the following came to me: UPD: asked to measure the resistance of the contacts. for 2.8mm 6mV (1.2mΩ) ) In particular, I ordered sets of dad and mom of 100 pieces in sizes https://jiji.ng/lagos-mainland/cars/toyota-avalon-2007 2.8 / 4.8 /6.3mm here, long dads 6.3 with a lock here, moms 6.3 with a lock here.
In general, four-way terminals can be taken, but, I repeat, for non-critical applications. It is better to buy normal thick metal terminals either in electrical stores or order online, but from well-known manufacturers in order to see the declared characteristics in advance. Replenishing stocks.

"Automobile" terminals. Well, I want to immediately draw your attention to the fact that in this case the metal is usually thin, although it is quite rigid, but these are definitely terminals for non-critical applications, for any low current and small sections. The sizes are like this. for 6.3mm 4mV (0.8mΩ)